Thermodynamics Research Center / ThermoML | Journal of Chemical and Engineering Data

Density, Surface Tension, and Viscosity of Ionic Liquids (1-Ethyl-3-methylimidazolium diethylphosphate and 1,3-Dimethylimidazolium dimethylphosphate) Aqueous Ternary Mixtures with MDEA

Ghani, N. A.[Noraini Abd], Sairi, N. A.[Nor Asrina], Aroua, M. K.[Mohamed Kheireddine], Alias, Y.[Yatimah], Yusoff, R.[Rozita]
J. Chem. Eng. Data 2014, 59, 6, 1737-1746
ABSTRACT
The density, surface tension, and viscosity of ionic liquids (1-ethyl-3-methylimidazolium diethylphosphate and 1,3-dimethylimidazolium dimethylphosphate) and ternary mixtures with aqueous MDEA, were measured over the whole concentrations range at various temperatures (293.15 343.15) K by using Anton Paar DMA 4500 densimeter, Kruss Processor Tensiometer K100, and R/S+ Brookfield rheometer. The experimental density and surface tension decrease linearly with mole fractions of ionic liquids. Data on viscosity demonstrates a temperature-dependence behavior, that decreased nonlinearly with temperature. Evaluations of the measured physicochemical properties were completed. The best correlation for density and surface tension data were linear fitting, while the viscosity data was obtained by polynomial regression. ILs mole fraction also influenced the experimental density, surface tension, and viscosity. The Jouyban Acree model was used to correlate the physicochemical properties of the mixtures and pure compounds at different temperatures. The absolute percentage error (APER) for each correlations was less than 8 %, proving that this model accurately represents the physicochemical properties data.
Compounds
# Formula Name
1 C10H21N2O4P 1-ethyl-3-methylimidazolium diethyl phosphate
2 C7H15N2O4P 1,3-dimethylimidazolium dimethylphosphate
3 C5H13NO2 N-methyldiethanolamine
4 H2O water
Datasets
The table above is generated from the ThermoML associated json file (link above). POMD and RXND refer to PureOrMixture and Reaction Datasets. The compound numbers are included in properties, variables, and phases, if specificied; the numbers refer to the table of compounds on the left.
Type Compound-# Property Variable Constraint Phase Method #Points
  • POMD
  • 3
  • Mass density, kg/m3 ; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • VIBTUB:UFactor:8
  • 3
  • POMD
  • 3
  • Viscosity, Pa*s ; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • Concentric cylinders viscometry
  • 4
  • POMD
  • 3
  • Surface tension liquid-gas, N/m ; Liquid
  • Temperature, K; Liquid
  • Liquid
  • Air at 1 atmosphere
  • Ring tensiometer
  • 2
  • POMD
  • 3
  • 4
  • 1
  • Mass density, kg/m3 ; Liquid
  • Temperature, K; Liquid
  • Mole fraction - 1; Liquid
  • Mole fraction - 3; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • Vibrating tube method
  • 63
  • POMD
  • 3
  • 4
  • 1
  • Surface tension liquid-gas, N/m ; Liquid
  • Temperature, K; Liquid
  • Mole fraction - 1; Liquid
  • Mole fraction - 3; Liquid
  • Liquid
  • Air at 1 atmosphere
  • Ring tensiometer
  • 63
  • POMD
  • 3
  • 4
  • 1
  • Viscosity, Pa*s ; Liquid
  • Temperature, K; Liquid
  • Mole fraction - 1; Liquid
  • Mole fraction - 3; Liquid
  • Liquid
  • Air at 1 atmosphere
  • Concentric cylinders viscometry
  • 63
  • POMD
  • 3
  • 4
  • 2
  • Mass density, kg/m3 ; Liquid
  • Temperature, K; Liquid
  • Mole fraction - 2; Liquid
  • Mole fraction - 3; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • Vibrating tube method
  • 70
  • POMD
  • 3
  • 4
  • 2
  • Surface tension liquid-gas, N/m ; Liquid
  • Temperature, K; Liquid
  • Mole fraction - 2; Liquid
  • Mole fraction - 3; Liquid
  • Liquid
  • Air at 1 atmosphere
  • Ring tensiometer
  • 70
  • POMD
  • 3
  • 4
  • 2
  • Viscosity, Pa*s ; Liquid
  • Temperature, K; Liquid
  • Mole fraction - 2; Liquid
  • Mole fraction - 3; Liquid
  • Liquid
  • Air at 1 atmosphere
  • Concentric cylinders viscometry
  • 70