This paper presents experimental data on the surface tensions of aqueous solutions of sodium alkyl sulfates (ionic surfactants) in contact with methane at a pressure of 3.90 MPa and a temperature of 275 K (i.e., a condition in which a clathrate hydrate of methane is thermodynamically stable). These data were obtained in the metastable absence of any hydrate in the experimental system (i.e., every measurement was accomplished during the induction time for hydrate formation). Three sodium alkyl sulfates appreciably different in length of the hydrophobic radicals were usedsthey were sodium dodecyl sulfate (SDS), sodium tetradecyl sulfate (STS), and sodium hexadecyl sulfate (SHS). The concentration of each of these surfactants was varied over a range including the critical concentration above which the surface tension levels off. On the basis of visual observations of pendant drops of SDS solutions, we identified the critical concentration for SDS as the solubility above which a hydrated solid of SDS forms instead of the critical micelle concentration (CMC) above which micelles of SDS would form. The SDS solubility was thus determined to be (2.2 to 2.3) gakg-1, which agrees, within mutual uncertainties, with the CMC determined at a higher temperature, 293 K, either in the same pressurized methane ambience or in the air under atmospheric pressure. These results completely conflict with those reported by Sun et al. in their recent paper published in this Journal (J. Chem. Eng. Data 2004, 49, 1023-1025).
Compounds
#
Formula
Name
1
CH4
methane
2
C12H25NaO4S
sodium dodecyl sulfate
3
C14H29NaO4S
sodium tetradecyl sulfate
4
C16H33NaO4S
sodium hexadecyl sulfate
5
H2O
water
Datasets
The table above is generated from the ThermoML associated json file (link above).
POMD and RXND refer to PureOrMixture and Reaction Datasets. The compound numbers are included in properties, variables, and phases, if specificied;
the numbers refer to the table of compounds on the left.
Type
Compound-#
Property
Variable
Constraint
Phase
Method
#Points
POMD
1
2
5
Surface tension liquid-gas, N/m ; Liquid
Temperature, K; Liquid
Solvent: Mass ratio of component to other component of binary solvent - 2; Liquid
Pressure, kPa; Liquid
Liquid
Gas
Pendant drop shape
18
POMD
1
3
5
Surface tension liquid-gas, N/m ; Liquid
Solvent: Mass ratio of component to other component of binary solvent - 3; Liquid
Temperature, K; Liquid
Pressure, kPa; Liquid
Liquid
Gas
Pendant drop shape
6
POMD
1
4
5
Surface tension liquid-gas, N/m ; Liquid
Solvent: Mass ratio of component to other component of binary solvent - 4; Liquid