Thermodynamics Research Center / ThermoML | Journal of Chemical Thermodynamics

Synergistic effect of salts and methanol in thermodynamic inhibition of sII gas hydrates

Semenov, A. P.[Anton P.], Stoporev, A. S.[Andrey S.], Mendgaziev, R. I.[Rais I.], Gushchin, P. A.[Pavel A.], Khlebnikov, V. N.[Vadim N.], Yakushev, V. S.[Vladimir S.], Istomin, V. A.[Vladimir A.], Sergeeva, D. V.[Daria V.], Vinokurov, V. A.[Vladimir A.]
J. Chem. Thermodyn. 2019, 137, 119-130
ABSTRACT
In this work phase equilibrium conditions for structure II (sII) gas hydrates in systems containing a mixture of salts (NaCl, KCl, CaCl2, MgCl2) and methanol have been measured using a high-pressure cell. The concentration of salts in aqueous solution (model of reservoir water) was constant in all experiments and equal to 18 wt%. Phase equilibrium conditions were determined by the isochoric method for pressures ranging from 1 to 4.7 MPa and for mass fraction of methanol from 0 to 50 wt%. The experimental data were obtained for water + salts, water + methanol, and water + salts + methanol systems. From the results obtained, it follows that 20 wt% of methanol in distilled water (DW) gives the thermodynamic shift of the hydrate decomposition temperature close to the brine one. Mixtures of 10% methanol + brine and 20% methanol + brine significantly better reduce the equilibrium temperature of hydrate dissociation compared to samples with the similar total mass fraction of inhibitor (methanol) in water (30, 40 wt%). At the pressures of more than 4 MPa combination of 20 wt% methanol + brine provide the same thermodynamic inhibition as 50 wt% of methanol in water. Thus, the synergism of the methanol + salts mixtures in the thermodynamic inhibition of sII gas hydrates has been observed. Synergism manifested itself in a greater shift of equilibrium curves to lower temperatures and higher pressures compared to systems containing only one thermodynamic hydrate inhibitor (THI). The obtained results indicate the possibility of a significant reduction in the consumption of polar organic THI for gas hydrate prevention in deposits with highly mineralized brine. However, it is necessary to take into account the possible complications associated with the precipitation of salts from solutions of water salt(s) polar organic THI due to the possible limited mutual solubility of the components.
Compounds
# Formula Name
1 H2O water
2 CH4O methanol
Datasets
The table above is generated from the ThermoML associated json file (link above). POMD and RXND refer to PureOrMixture and Reaction Datasets. The compound numbers are included in properties, variables, and phases, if specificied; the numbers refer to the table of compounds on the left.
Type Compound-# Property Variable Constraint Phase Method #Points
  • POMD
  • 2
  • Refractive index (Na D-line) ; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • Standard Abbe refractometry
  • 1
  • POMD
  • 2
  • 1
  • Mass density, kg/m3 ; Liquid
  • Mass fraction - 2; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • Vibrating tube method
  • 12
  • POMD
  • 2
  • 1
  • Viscosity, Pa*s ; Liquid
  • Mass fraction - 2; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • Falling or rolling sphere viscometry
  • 12