Thermodynamics Research Center / ThermoML | Journal of Chemical Thermodynamics

Enthalpy of formation of 5-fluoro-1,3-dimethyluracil: 5-Fluorouracil revisited

Amaral, L. M. P. F.[Luisa M.P.F.], Szterner, P.[Piotr], Miranda, M. S.[Margarida S.], Ribeiro da Silva, M. A. V.[Manuel A.V.]
J. Chem. Thermodyn. 2014, 75, 106-115
ABSTRACT
In the present work, a re-determination of thermochemical data for 5-fluorouracil was performed and a new determination of thermochemical parameters for 5-fluoro-1,3-dimethyluracil are presented. The standard (po = 0.1 MPa) molar enthalpies of formation, in the crystalline phase, of 5-fluorouracil and 5-fluoro-1,3-dimethyluracil, at T = 298.15 K, were derived from the standard molar energies of combustion in oxygen, measured by rotating bomb combustion calorimetry. For these compounds, the standard molar enthalpies of sublimation, at T = 298.15 K, were determined from the temperature-vapour pressure dependence, obtained by the Knudsen mass-loss effusion method. Using the values for the heat capacity differences between the gas and the crystalline phases of the compounds studied, the standard (po = 0.1 MPa) molar enthalpies, entropies and Gibbs free energies of sublimation, at T = 298.15 K, were derived. From the experimentally determined values, the standard molar enthalpies of formation, in the gas phase, at T = 298.15 K, of 5-fluorouracil and 5-fluoro-1,3-dimethyluracil were calculated as (454.5 +- 1.6) and (478.5 +- 1.3) kJ mol 1, respectively. These values were compared with estimates obtained from very accurate theoretical calculations using the G3(MP2)//B3LYP composite method and appropriately chosen reactions.
Compounds
# Formula Name
1 FH hydrogen fluoride
2 CO2 carbon dioxide
3 N2 nitrogen
4 H2O water
5 O2 oxygen
6 C4H3FN2O2 5-fluoro-2,4(1H,3H)-pyrimidinedione
7 C6H7FN2O2 2,4(1H,3H)-pyrimidinedione, 5-fluoro-1,3-dimethyl-
Datasets
The table above is generated from the ThermoML associated json file (link above). POMD and RXND refer to PureOrMixture and Reaction Datasets. The compound numbers are included in properties, variables, and phases, if specificied; the numbers refer to the table of compounds on the left.
Type Compound-# Property Variable Constraint Phase Method #Points
  • POMD
  • 6
  • Vapor or sublimation pressure, kPa ; Crystal
  • Temperature, K; Crystal
  • Crystal
  • Gas
  • Calculated from knudsen effusion weight loss
  • 36
  • POMD
  • 7
  • Vapor or sublimation pressure, kPa ; Crystal
  • Temperature, K; Crystal
  • Crystal
  • Gas
  • Calculated from knudsen effusion weight loss
  • 36
  • RXND
  • 6
  • 1
  • 2
  • 3
  • 4
  • 5
  • Specific internal energy of reaction at constant volume, J/g
  • Rotating bomb calorimetry
  • 1
  • RXND
  • 7
  • 1
  • 2
  • 3
  • 4
  • 5
  • Specific internal energy of reaction at constant volume, J/g
  • Rotating bomb calorimetry
  • 1