Thermodynamics Research Center / ThermoML | Journal of Chemical Thermodynamics

Highly precise (liquid + liquid) equilibrium and heat capacity measurements near the critical point for [Bmim][BF4] + 1H, 1H, 2H, 2H perfluoroctanol

Perez-Sanchez, G., Troncoso, J., Losada-Perez, P., Mendez-Castro, P., Romani, L.
J. Chem. Thermodyn. 2013, 65, 131-137
ABSTRACT
Liquid + liquid equilibrium of the system [Bmim][BF4] + 1H, 1H, 2H, 2H perfluoroctanol using a highly precise methodology based on refractive index measurements was experimentally determined. In addition, isobaric heat capacity near the critical point was obtained. The performance of the new refractive index set-up was successfully checked against the coexistence curve of the system dimethyl carbonate + decane, since highly accurate data are available in the literature. The choice of [Bmim][BF4] + 1H, 1H, 2H, 2H perfluoroctanol was motivated by a previous experimental work, whose results suggest that this system could present characteristics of both solvophobic and coulombic behavior, which are the two categories to which an ionic system can belong. Although this was previously observed for other ionic systems, this mixture presented a very striking feature: the diameter of the coexistence curve seemed to change its criticality in the studied temperature range, from solvophobic far away to coulombic close to the critical point. The results of this work reveal that, in fact, [Bmim][BF4] + 1H, 1H, 2H, 2H perfluoroctanol presents characteristics of both solvophobic and coulombic criticality, but no evidence of the observed crossover over the experimental temperature range has been found.
Compounds
# Formula Name
1 C8H15BF4N2 1-butyl-3-methylimidazolium tetrafluoroborate
2 C8H5F13O 1H,1H,2H,2H-perfluorooctanol
3 C3H6O3 dimethyl carbonate
4 C10H22 decane
Datasets
The table above is generated from the ThermoML associated json file (link above). POMD and RXND refer to PureOrMixture and Reaction Datasets. The compound numbers are included in properties, variables, and phases, if specificied; the numbers refer to the table of compounds on the left.
Type Compound-# Property Variable Constraint Phase Method #Points
  • POMD
  • 1
  • Mass density, kg/m3 ; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • Vibrating tube method
  • 9
  • POMD
  • 1
  • Refractive index (other wavelength) ; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Wavelength, nm; Liquid
  • Liquid
  • Standard Abbe refractometry
  • 5
  • POMD
  • 2
  • Mass density, kg/m3 ; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • Vibrating tube method
  • 9
  • POMD
  • 2
  • Refractive index (other wavelength) ; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Wavelength, nm; Liquid
  • Liquid
  • Standard Abbe refractometry
  • 6
  • POMD
  • 2
  • Relative permittivity at various frequencies ; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Frequency, MHz; Liquid
  • Liquid
  • Parallel plate capacitor
  • 5
  • POMD
  • 4
  • 3
  • Upper consolute temperature, K ; Liquid mixture 1
  • Liquid mixture 1
  • Liquid mixture 2
  • Air at 1 atmosphere
  • from fitting of the LL coexistance curve
  • 1
  • POMD
  • 4
  • 3
  • Upper consolute composition: mole fraction - 4 ; Liquid mixture 1
  • Liquid mixture 1
  • Liquid mixture 2
  • Air at 1 atmosphere
  • from fitting of the LL coexistance curve
  • 1
  • POMD
  • 4
  • 3
  • Refractive index (other wavelength) ; Liquid
  • Mole fraction - 3; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Wavelength, nm; Liquid
  • Liquid
  • Standard Abbe refractometry
  • 64
  • POMD
  • 4
  • 3
  • Mole fraction - 3 ; Liquid mixture 1
  • Temperature, K; Liquid mixture 1
  • Pressure, kPa; Liquid mixture 1
  • Liquid mixture 1
  • Liquid mixture 2
  • Index of refraction calibration data
  • 32
  • POMD
  • 4
  • 3
  • Mole fraction - 3 ; Liquid mixture 2
  • Temperature, K; Liquid mixture 1
  • Pressure, kPa; Liquid mixture 1
  • Liquid mixture 2
  • Liquid mixture 1
  • Index of refraction calibration data
  • 32
  • POMD
  • 2
  • 1
  • Upper consolute temperature, K ; Liquid mixture 1
  • Liquid mixture 1
  • Liquid mixture 2
  • Air at 1 atmosphere
  • from fitting of the LL coexistance curve
  • 1
  • POMD
  • 2
  • 1
  • Upper consolute composition: mole fraction - 2 ; Liquid mixture 1
  • Liquid mixture 1
  • Liquid mixture 2
  • Air at 1 atmosphere
  • from fitting of the LL coexistance curve
  • 1
  • POMD
  • 2
  • 1
  • Refractive index (other wavelength) ; Liquid
  • Mole fraction - 1; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Wavelength, nm; Liquid
  • Liquid
  • Standard Abbe refractometry
  • 28
  • POMD
  • 2
  • 1
  • Mole fraction - 1 ; Liquid mixture 1
  • Temperature, K; Liquid mixture 1
  • Pressure, kPa; Liquid mixture 1
  • Liquid mixture 1
  • Liquid mixture 2
  • Index of refraction calibration data
  • 14
  • POMD
  • 2
  • 1
  • Mole fraction - 1 ; Liquid mixture 2
  • Temperature, K; Liquid mixture 1
  • Pressure, kPa; Liquid mixture 1
  • Liquid mixture 2
  • Liquid mixture 1
  • Index of refraction calibration data
  • 14