Thermodynamics Research Center / ThermoML | Journal of Chemical Thermodynamics

Measurements and predictions of density and carbon dioxide solubility in binary mixtures of ethanol and n-decane

Nourozieh, H.[Hossein], Kariznovi, M.[Mohammad], Abedi, J.[Jalal]
J. Chem. Thermodyn. 2013, 58, 377-384
ABSTRACT
The solubility of carbon dioxide (CO2) in binary mixtures of ethanol and n-decane has been measured using an in-house developed pressure-volume-temperature (PVT) apparatus at pressures up to 6 MPa and two different temperatures (303.2 and 323.2 K). Three different binary mixtures of ethanol and n-decane were prepared, and the densities of the prepared mixtures were measured over the studied pressure and temperature ranges. The experimental data of CO2 solubility in the prepared mixtures and their saturated liquid densities were then reported at each temperature and pressure. The solubility data indicated that the gas solubility reduced as the ethanol mole fraction in the liquid mixture increased. The dissolution of CO2 in the liquid mixtures resulted in the increase in the saturated liquid densities. The impact of gas dissolution on the saturated liquid densities was more pronounced at the lower temperature and lower ethanol compositions. The experimental solubility and density data were compared with the results of two cubic equations of state (EOSs), Soave Redlich Kwong (SRK) and Peng Robinson (PR). The modeling results demonstrated that both EOSs could predict the solubility data well, while the saturated liquid densities calculated with the PR EOS were much better than those predicted with the SRK EOS.
Compounds
# Formula Name
1 CO2 carbon dioxide
2 C2H6O ethanol
3 C10H22 decane
Datasets
The table above is generated from the ThermoML associated json file (link above). POMD and RXND refer to PureOrMixture and Reaction Datasets. The compound numbers are included in properties, variables, and phases, if specificied; the numbers refer to the table of compounds on the left.
Type Compound-# Property Variable Constraint Phase Method #Points
  • POMD
  • 2
  • 3
  • Mass density, kg/m3 ; Liquid
  • Mole fraction - 2; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • Vibrating tube method
  • 66
  • POMD
  • 2
  • 3
  • 1
  • Mass density, kg/m3 ; Liquid
  • Solvent: Mole fraction - 2; Liquid
  • Pressure, kPa; Liquid
  • Mole fraction - 1; Liquid
  • Temperature, K; Liquid
  • Liquid
  • Other PVT measurement
  • 18
  • POMD
  • 2
  • 3
  • 1
  • Mass density, kg/m3 ; Liquid
  • Solvent: Mole fraction - 2; Liquid
  • Pressure, kPa; Liquid
  • Mole fraction - 1; Liquid
  • Temperature, K; Liquid
  • Liquid
  • Other PVT measurement
  • 18