Thermodynamics Research Center / ThermoML | Fluid Phase Equilibria

Interfacial tensions of (H2O + H2) and (H2O + CO2 + H2) systems at temperatures of (298-448) K and pressures up to 45 MPa

Chow, Y.T. Florence, Maitland, Geoffrey C., Trusler, J.P. Martin
Fluid Phase Equilib. 2018, 475, 37-44
ABSTRACT
We report new interfacial tension (IFT) measurements of the (H2O + CO2 + H2) and (H2O + H2) systems at pressures of (0.5 to 45) MPa, and temperatures of (298.15 to 448.15) K, measured by the pendant-drop method. The expanded uncertainties at 95% confidence are 0.05 K for temperature, 70 kPa for pressure, 0.017*gamma for IFT in the both the binary (H2O + H2) system and the ternary (CO2 + H2 + H2O) system. Generally, the IFT was found to decrease with both increasing pressure and increasing temperature. However, for (H2O + H2) at the lowest two temperatures investigated, the isothermal IFT data were found to exhibit a maximum as a function of pressure at low pressures before declining with increasing pressure. An empirical correlation has been developed for the IFT of the (H2O + H2) system in the full range of conditions investigated, with an average absolute deviation of 0.16 mN m-1, and this is used to facilitate a comparison with literature values. Estimates of the IFT of the (H2O + CO2 + H2) ternary system, by an empirical combining rule based on the coexisting phase compositions and the interfacial tensions of the binary systems, were found to be unsuitable at low temperatures, with an average absolute deviation of 3.6 mN m-1 over all the conditions investigated.
Compounds
# Formula Name
1 H2O water
2 H2 hydrogen
3 CO2 carbon dioxide
Datasets
The table above is generated from the ThermoML associated json file (link above). POMD and RXND refer to PureOrMixture and Reaction Datasets. The compound numbers are included in properties, variables, and phases, if specificied; the numbers refer to the table of compounds on the left.
Type Compound-# Property Variable Constraint Phase Method #Points
  • POMD
  • 1
  • 2
  • Interfacial tension, N/m ; Liquid - 1
  • Pressure, kPa; Liquid - 1
  • Temperature, K; Liquid - 1
  • Liquid - 1
  • Gas
  • Pendant drop shape
  • 43
  • POMD
  • 3
  • 1
  • 2
  • Interfacial tension, N/m ; Liquid
  • Mole fraction - 3; Liquid
  • Pressure, kPa; Liquid
  • Temperature, K; Liquid
  • Liquid
  • Gas
  • Pendant drop shape
  • 36
  • POMD
  • 3
  • 1
  • 2
  • Interfacial tension, N/m ; Liquid
  • Mole fraction - 1; Liquid
  • Pressure, kPa; Liquid
  • Temperature, K; Liquid
  • Liquid
  • Gas
  • Pendant drop shape
  • 36
  • POMD
  • 3
  • 1
  • 2
  • Interfacial tension, N/m ; Liquid
  • Mole fraction - 3; Gas
  • Pressure, kPa; Liquid
  • Temperature, K; Liquid
  • Liquid
  • Gas
  • Pendant drop shape
  • 36
  • POMD
  • 3
  • 1
  • 2
  • Interfacial tension, N/m ; Liquid
  • Mole fraction - 1; Gas
  • Pressure, kPa; Liquid
  • Temperature, K; Liquid
  • Liquid
  • Gas
  • Pendant drop shape
  • 36