Thermodynamics Research Center / ThermoML | Fluid Phase Equilibria

Influence of temperature on the (liquid + liquid) equilibria of {methanol + benzene + hexane} ternary system

Gramajo de Doz, M. B.[Monica B.], Bonatti, C. M.[Carlos M.], Lucena, M. C.[Maria C.], Gonzalez, D.[Diego], Mancilla, M. E.[Marcos E.]
Fluid Phase Equilib. 2011, 305, 1, 34-38
ABSTRACT
In order to show the influence of temperature on the liquid-liquid equilibria (LLE) of {methanol (1) + benzene (2) + hexane (3)} ternary system, equilibrium data at T = (278.15, 283.15, and 293.15) K are reported. The effect of the temperature on liquid-liquid equilibrium is determined and discussed. Ternary system is available from the literature at T = 298 K. All chemicals were quantified by gas chromatography using a thermal conductivity detector. The solubility data for methanol + hexane and the upper critical temperature (UCST) at 308.3K was reported. The tie line data for the ternary system were satisfactorily correlated by the Othmer and Tobias method, and the plait point coordinates for the three temperatures were estimated. Experimental data for the ternary system are compared with values calculated by the NRTL and UNIQUAC equations, and predicted by means of the UNIFAC group contribution method. It is found that the UNIQUAC and NRTL models provide similar good correlations of the equilibrium data at these three temperatures. Finally, the UNIFAC model predicts an immiscibility region larger than the experimental observed. Distribution coefficients were also analysed through distribution curves.
Compounds
# Formula Name
1 CH4O methanol
2 C6H6 benzene
3 C6H14 hexane
Datasets
The table above is generated from the ThermoML associated json file (link above). POMD and RXND refer to PureOrMixture and Reaction Datasets. The compound numbers are included in properties, variables, and phases, if specificied; the numbers refer to the table of compounds on the left.
Type Compound-# Property Variable Constraint Phase Method #Points
  • POMD
  • 1
  • 3
  • Mass fraction - 1 ; Liquid mixture 2
  • Temperature, K; Liquid mixture 2
  • Pressure, kPa; Liquid mixture 2
  • Liquid mixture 2
  • Liquid mixture 1
  • Chromatography
  • 3
  • POMD
  • 1
  • 3
  • Mass fraction - 1 ; Liquid mixture 1
  • Temperature, K; Liquid mixture 2
  • Pressure, kPa; Liquid mixture 2
  • Liquid mixture 1
  • Liquid mixture 2
  • Chromatography
  • 3
  • POMD
  • 1
  • 2
  • 3
  • Mass fraction - 2 ; Liquid mixture 1
  • Mass fraction - 2 ; Liquid mixture 2
  • Mass fraction - 1 ; Liquid mixture 2
  • Temperature, K; Liquid mixture 2
  • Mass fraction - 1; Liquid mixture 1
  • Pressure, kPa; Liquid mixture 2
  • Liquid mixture 1
  • Liquid mixture 2
  • Chromatography
  • Chromatography
  • Chromatography
  • 18