Thermodynamics Research Center / ThermoML | Fluid Phase Equilibria

Diffusion coefficients and molar conductivities in aqueous solutions of 1-ethyl-3-methylimidazolium-based ionic liquids

Wong, C.-L.[Chun-Li], Soriano, A. N.[Allan N.], Li, M. -H.[Meng-Hui]
Fluid Phase Equilib. 2008, 271, 1-2, 43-52
ABSTRACT
Here, we presented new experimental data of diffusion coefficients of five [Emim, (1-ethyl-3- methylimidazolium)]-based ionic liquids in water at infinite dilution for temperatures ranging from 303.2 to 323.2K using Taylor dispersion method. The investigated ILs were [Emim][C2N3 (dicyanamide)], Emim][BF4 (tetrafluoroborate)], [Emim][C2H5SO4 (ethylsulfate)], [Emim][CF3SO3 (trifluoromethanesulfonate)], and [Emim][MDEGSO4 (2-(2-methoxyethoxy) ethylsulfate)]. The molar conductivities of these ionic liquids were also measured and the infinite dilution conductances were calculated. The temperature dependency of the present experimental diffusion coefficients of the studied ionic liquids in water at infinite dilution were correlated using three equations; namely, Wilke Chang, empirical (linear), and Nernst Haskell equation. The Wilke Chang equation underestimated the diffusion coefficient. Theempirical, a typical linear fit, satisfactory represented the present measurements of all the studied systems. The Nernst Haskell equation satisfactory predicted the diffusion coefficients of most of the ionic liquids under investigation. The self-diffusion coefficients of the studied ions at infinite dilutionwere also evaluated and briefly discussed. The present results could be very essential to the assessment of the impact of ionic liquid in the waste water stream since it is the most likely pollution it would contribute to the environment. (C) 2008 Elsevier B.V. All rights reserved.
Compounds
# Formula Name
1 C8H11N5 1-ethyl-3-methylimidazolium dicyanamide
2 C6H11BF4N2 1-ethyl-3-methylimidazolium tetrafluoroborate
3 C8H16N2O4S 1-ethyl-3-methylimidazolium ethyl sulfate
4 C7H11F3N2O3S 1-ethyl-3-methylimidazolium trifluoromethanesulfonate
5 C11H22N2O6S 1-ethyl-3-methylimidazolium 2-(2-methoxyethoxy) ethylsulfate
6 H2O water
7 BF4Li lithium fluoroborate
Datasets
The table above is generated from the ThermoML associated json file (link above). POMD and RXND refer to PureOrMixture and Reaction Datasets. The compound numbers are included in properties, variables, and phases, if specificied; the numbers refer to the table of compounds on the left.
Type Compound-# Property Variable Constraint Phase Method #Points
  • POMD
  • 1
  • Mass density, kg/m3 ; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • VIBTUB:UFactor:8
  • 5
  • POMD
  • 2
  • Mass density, kg/m3 ; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • VIBTUB:UFactor:24
  • 5
  • POMD
  • 3
  • Mass density, kg/m3 ; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • VIBTUB:UFactor:12
  • 5
  • POMD
  • 4
  • Mass density, kg/m3 ; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • VIBTUB:UFactor:16
  • 5
  • POMD
  • 5
  • Mass density, kg/m3 ; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • VIBTUB:UFactor:16
  • 5
  • POMD
  • 6
  • 1
  • Binary diffusion coefficient, m2/s ; Fluid (supercritical or subcritical phases)
  • Temperature, K; Fluid (supercritical or subcritical phases)
  • Mole fraction - 1; Fluid (supercritical or subcritical phases)
  • Pressure, kPa; Fluid (supercritical or subcritical phases)
  • Fluid (supercritical or subcritical phases)
  • TAYLOR:UFactor:4
  • 5
  • POMD
  • 6
  • 1
  • Molar conductivity, S*m2/mol ; Liquid
  • Amount concentration (molarity), mol/dm3 - 1; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • Direct current cell with electrodes
  • 25
  • POMD
  • 6
  • 2
  • Binary diffusion coefficient, m2/s ; Fluid (supercritical or subcritical phases)
  • Temperature, K; Fluid (supercritical or subcritical phases)
  • Mole fraction - 2; Fluid (supercritical or subcritical phases)
  • Pressure, kPa; Fluid (supercritical or subcritical phases)
  • Fluid (supercritical or subcritical phases)
  • TAYLOR:UFactor:4
  • 5
  • POMD
  • 6
  • 2
  • Molar conductivity, S*m2/mol ; Liquid
  • Amount concentration (molarity), mol/dm3 - 2; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • Direct current cell with electrodes
  • 25
  • POMD
  • 6
  • 3
  • Binary diffusion coefficient, m2/s ; Fluid (supercritical or subcritical phases)
  • Temperature, K; Fluid (supercritical or subcritical phases)
  • Mole fraction - 3; Fluid (supercritical or subcritical phases)
  • Pressure, kPa; Fluid (supercritical or subcritical phases)
  • Fluid (supercritical or subcritical phases)
  • TAYLOR:UFactor:4
  • 5
  • POMD
  • 6
  • 3
  • Molar conductivity, S*m2/mol ; Liquid
  • Amount concentration (molarity), mol/dm3 - 3; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • Direct current cell with electrodes
  • 25
  • POMD
  • 6
  • 4
  • Binary diffusion coefficient, m2/s ; Fluid (supercritical or subcritical phases)
  • Temperature, K; Fluid (supercritical or subcritical phases)
  • Mole fraction - 4; Fluid (supercritical or subcritical phases)
  • Pressure, kPa; Fluid (supercritical or subcritical phases)
  • Fluid (supercritical or subcritical phases)
  • TAYLOR:UFactor:4
  • 5
  • POMD
  • 6
  • 4
  • Molar conductivity, S*m2/mol ; Liquid
  • Amount concentration (molarity), mol/dm3 - 4; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • Direct current cell with electrodes
  • 25
  • POMD
  • 6
  • 5
  • Binary diffusion coefficient, m2/s ; Fluid (supercritical or subcritical phases)
  • Temperature, K; Fluid (supercritical or subcritical phases)
  • Mole fraction - 6; Fluid (supercritical or subcritical phases)
  • Pressure, kPa; Fluid (supercritical or subcritical phases)
  • Fluid (supercritical or subcritical phases)
  • TAYLOR:UFactor:4
  • 5
  • POMD
  • 6
  • 5
  • Molar conductivity, S*m2/mol ; Liquid
  • Amount concentration (molarity), mol/dm3 - 5; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • Direct current cell with electrodes
  • 25
  • POMD
  • 6
  • 7
  • Molar conductivity, S*m2/mol ; Liquid
  • Amount concentration (molarity), mol/dm3 - 7; Liquid
  • Temperature, K; Liquid
  • Pressure, kPa; Liquid
  • Liquid
  • Direct current cell with electrodes
  • 25