Thermodynamics Research Center / ThermoML | Fluid Phase Equilibria

Measurement and modelling of urea solubility in supercritical CO2 and CO2 + ethanol mixtures

Catchpole, O. J.[Owen J.], Tallon, S. J., Dyer, P. J., Lan, J.-S., Jensen, B., Rasmussen, O. K., Grey, J. B.
Fluid Phase Equilib. 2005, 237, 1-2, 212-218
ABSTRACT
The solubility of urea in supercriticalCO2 andCO2 + ethanolwas measured over the pressure and temperature ranges 100 300 bar and 313 373 K, respectively, and ethanol concentrations of 0 25 mass% (urea free basis). The solubility in CO2 was measured by a once-through packed bed gravimetric method at a laboratory and pilot scale. The solubility in CO2 + ethanol was measured using two different methods: antisolvent precipitation and a gravimetric packed bed method. The solubility of urea in pure CO2 is very low, ranging from 1.1*10-6 mol fraction at 100 bar, 333K to 3.1*10-5 at 300 bar, 353 K. The solubility increases exponentially with a linear increase in ethanol content. The highest solubility measured was ~1*10-2 mol fraction at 333 K, 150 bar and 26% ethanol. At high ethanol contents, the solubility was almost independent of pressure at a fixed temperature. The solubility was correlated by the Peng Robinson equation of state with standard mixing rules for the repulsive and attractive parameters; and mixing rules that incorporated the formation of a complex between urea and ethanol. The solubility of urea in ethanol, and ethanol in CO2 was also modelled to obtain interaction parameters for the model. It was not possible to find pairs of interaction parameters that modelled both the solubility in pure CO2, and CO2 + ethanol using the standard Peng Robinson mixing rules. However, the solubility of urea in pure CO2, and CO2 + ethanol, was well modelled using the Peng Robinson EOS that incorporated complex formation between urea and ethanol. Assuming an ethanol/urea complex stoichiometry of 2:1 gave a good fit between model predictions and experimental results.
Compounds
# Formula Name
1 CH4N2O urea
2 C2H6O ethanol
3 CO2 carbon dioxide
Datasets
The table above is generated from the ThermoML associated json file (link above). POMD and RXND refer to PureOrMixture and Reaction Datasets. The compound numbers are included in properties, variables, and phases, if specificied; the numbers refer to the table of compounds on the left.
Type Compound-# Property Variable Constraint Phase Method #Points
  • POMD
  • 1
  • 3
  • Mole fraction - 1 ; Fluid (supercritical or subcritical phases)
  • Temperature, K; Fluid (supercritical or subcritical phases)
  • Pressure, kPa; Fluid (supercritical or subcritical phases)
  • Fluid (supercritical or subcritical phases)
  • Crystal - 1
  • gravimetric method
  • 4
  • POMD
  • 1
  • 2
  • Mole fraction - 1 ; Fluid (supercritical or subcritical phases)
  • Temperature, K; Fluid (supercritical or subcritical phases)
  • Pressure, kPa; Fluid (supercritical or subcritical phases)
  • Fluid (supercritical or subcritical phases)
  • Crystal - 1
  • gravimetric method
  • 3
  • POMD
  • 1
  • 2
  • 3
  • Mole fraction - 1 ; Fluid (supercritical or subcritical phases)
  • Temperature, K; Fluid (supercritical or subcritical phases)
  • Pressure, kPa; Fluid (supercritical or subcritical phases)
  • Solvent: Mole fraction - 2; Fluid (supercritical or subcritical phases)
  • Fluid (supercritical or subcritical phases)
  • Crystal - 1
  • gravimetric method
  • 89