Thermodynamics Research Center / ThermoML | Fluid Phase Equilibria

The experiments and correlations of the solubility of ethylene in toluene solvent

Lee, L. -[Liang-sun], Ou, H.-J.[Hsin-Jung], Hsu, H. -L.[Hsiu-ling]
Fluid Phase Equilib. 2005, 231, 2, 221-230
ABSTRACT
Polymer cyclic olefin copolymer (COC) is produced from the reaction of attaching ethyl groups to the norbornene monomer in liquid phase. The first step of process is dissolving ethylene in a liquid phase where toluene is present as a cosolvent. Thus, the solubility of ethylene in liquid toluene is the most important factor affecting the production of COC. In this study, the solubility of ethylene in toluene was measured in the temperature range from 323.15 to 423.15K and pressure range from 5 to 25 bar. The experiments were conducted by the method of pressure decaying with a newly designed apparatus. The experimental results show that the solubility of ethylene in toluene increases with increasing pressure but decreases with increasing temperature. The experimental solubility data were expressed in the vapor liquid equilibrium relationship and correlated fairly well by the bubble pressure calculation with the Peng Robinson equation of state (PR EOS) incorporated with the van der Waals one-fluid and the Zhong Masuoka mixing rules with the consideration of binary interaction parameters. The results showed the van derWaals (vdW-1) mixing rule is slightly better than the Z M mixing rule for pressure correlation but the Z M mixing rule is slightly better for vapor composition correlation. A semi-empirical solubility equation with four parameters for the present binary system was proposed in this study. This proposed model estimates the solubility easier and as accurate as the PR EOS does for the present system.
Compounds
# Formula Name
1 CO2 carbon dioxide
2 C2H4 ethene
3 C7H8 toluene
Datasets
The table above is generated from the ThermoML associated json file (link above). POMD and RXND refer to PureOrMixture and Reaction Datasets. The compound numbers are included in properties, variables, and phases, if specificied; the numbers refer to the table of compounds on the left.
Type Compound-# Property Variable Constraint Phase Method #Points
  • POMD
  • 3
  • 1
  • Mole fraction - 1 ; Liquid
  • Pressure, kPa; Liquid
  • Temperature, K; Liquid
  • Liquid
  • Gas
  • CHROM:UFactor:8
  • 9
  • POMD
  • 2
  • 3
  • Vapor or sublimation pressure, kPa ; Liquid
  • Mole fraction - 2; Liquid
  • Temperature, K; Liquid
  • Liquid
  • Gas
  • CCELL:UFactor:16
  • 18
  • POMD
  • 2
  • 3
  • Mole fraction - 2 ; Gas
  • Mole fraction - 2; Liquid
  • Temperature, K; Liquid
  • Gas
  • Liquid
  • CHROM:UFactor:4
  • 18